Vestel Venus Go Read Firmware

[adnanmirsad56]

Merhaba GSM Turkey Üyeleri bu paylaşacağım konuda Vestel Venüs Go cihazının yazılımı nasıl çekilir onu anlatacağım.

Bu işlemi yapabilmek için elinizde UMT Dongle olması lazım. Bu araç ücretli bir araçtır ve genellikle cep telefonu tamir yapan yerlerde mevcuttur.

Cihazı edl moda alıp işlemi başlatın.

 Operation    : Read Firmware
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port    : HS-USB Diagnostics 9008 (COM23)
Driver Info    : Mobile, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID    : E1009600 [8909] 00000000
OPK_DATA    : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A26AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [2]
Preparing Loader...Done
Sending Loader [8909_012]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware    : 8909, eMMC, 8 GB
LU Count    : 1 [0x00E90000] 
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info    : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
USERDATA    : Encrypted
Reading USERDATA will cause large firmware size and slow read speed.
Reading Device Information...OK
Software    : 1.08.0, eng.builds.20180905.160628 [Wed Sep  5 16:06:28 +03 2018]
Android Ver.    : 8.1.0
Patch Level    : 2018-07-01
Reading [modem]...Done
Reading [DDR]...Done
Reading [sec]...Done
Reading [boot]...Done
Reading [system]...Done
Reading [persist]...Done
Reading [cache]...Done
Reading [recovery]...Done
Reading [cmnlib]...Done
Reading [cmnlibbak]...Done
Reading [keymaster]...Done
Reading [keymasterbak]...Done
Reading [sbl1]...Done
Reading [sbl1bak]...Done
Reading [aboot]...Done
Reading [abootbak]...Done
Reading [rpm]...Done
Reading [rpmbak]...Done
Reading [tz]...Done
Reading [tzbak]...Done
Reading [modemst1]...Done
Reading [modemst2]...Done
Reading [misc]...Done
Reading [splash]...Done
Reading [gpt_main0]...Done
Reading [gpt_back0]...Done
Saved to    : C:\UMTool\QcFire\Read\_1.08.0_2018-07-01\
Operation Finished.
QcFire Ver. 5.5