- Katılım
- 21 Haz 2018
- Mesajlar
- 11,487
- Tepkime puanı
- 28,061
- Puanları
- 113
Çevrimdışı
VIP üyeler dosyaya Buradan ulaşabilirler.
Kod:
Operation : Read Firmware
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : HS-USB Diagnostics 9008 (COM23)
Driver Info : Mobile, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 00000000
OPK_DATA : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A26AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [2]
Preparing Loader...Done
Sending Loader [8909_012]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 8 GB
LU Count : 1 [0x00E90000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
USERDATA : Encrypted
Reading USERDATA will cause large firmware size and slow read speed.
Reading Device Information...OK
Software : 1.08.0, eng.builds.20180905.160628 [Wed Sep 5 16:06:28 +03 2018]
Android Ver. : 8.1.0
Patch Level : 2018-07-01
Reading [modem]...Done
Reading [DDR]...Done
Reading [sec]...Done
Reading [boot]...Done
Reading [system]...Done
Reading [persist]...Done
Reading [cache]...Done
Reading [recovery]...Done
Reading [cmnlib]...Done
Reading [cmnlibbak]...Done
Reading [keymaster]...Done
Reading [keymasterbak]...Done
Reading [sbl1]...Done
Reading [sbl1bak]...Done
Reading [aboot]...Done
Reading [abootbak]...Done
Reading [rpm]...Done
Reading [rpmbak]...Done
Reading [tz]...Done
Reading [tzbak]...Done
Reading [modemst1]...Done
Reading [modemst2]...Done
Reading [misc]...Done
Reading [splash]...Done
Reading [gpt_main0]...Done
Reading [gpt_back0]...Done
Saved to : C:\UMTool\QcFire\Read\_1.08.0_2018-07-01\
Operation Finished.
QcFire Ver. 5.5
Moderatör tarafında düzenlendi:
