silivriserdar
Genel Moderator
- Katılım
- 21 Haz 2018
- Mesajlar
- 21,976
- Tepkime puanı
- 44,636
- Puanları
- 113
- Yaş
- 40
Çevrimdışı
Merhaba GSM Turkey Üyeleri bu paylaşacağım konuda ZTE Nubia Red Magic 5G NX659J cihazının edl modda yazılımı nasıl çekilir onu anlatacağım.
Aynı zamanda bu yazılım ile brick olmuş cihazlarınızı kurtarma yapabilirsiniz.
Aynı zamanda bu yazılım ile brick olmuş cihazlarınızı kurtarma yapabilirsiniz.
Kod:
Operation : Read Firmware
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.0
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1300C00 [SD8250] 00000400
OPK_DATA : 8F7C1A63A23CE98FD673BFFBB5B17904A489379275DCB5B8C480977E796C0E86
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SD8250]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : SD8250, UFS, 256 GB
LU Count : 6 [0x03B04800] [0x00000800] [0x00000800] [0x00008000] [0x00080000] [0x00008000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
USERDATA : Encrypted
Reading USERDATA will cause large firmware size and slow read speed.
Reading Device Information...Failed
Reading [persist]...Done
Reading [misc]...Done
Reading [super]...Done
Reading [recovery]...Done
Reading [cache]...Done
Reading [gpt_main0]...Done
Reading [gpt_back0]...Done
Reading [xbl]...Done
Reading [gpt_main1]...Done
Reading [gpt_back1]...Done
Reading [xblbak]...Done
Reading [gpt_main2]...Done
Reading [gpt_back2]...Done
Reading [ddr]...Done
Reading [gpt_main3]...Done
Reading [gpt_back3]...Done
Reading [tz]...Done
Reading [hyp]...Done
Reading [modem]...Done
Reading [bluetooth]...Done
Reading [mdtp]...Done
Reading [dsp]...Done
Reading [keymaster]...Done
Reading [boot]...Done
Reading [cmnlib]...Done
Reading [cmnlib64]...Done
Reading [devcfg]...Done
Reading [tzbak]...Done
Reading [hypbak]...Done
Reading [keymasterbak]...Done
Reading [cmnlibbak]...Done
Reading [cmnlib64bak]...Done
Reading [devcfgbak]...Done
Reading [splash]...Done
Reading [gpt_main4]...Done
Reading [gpt_back4]...Done
Reading [gpt_main5]...Done
Reading [gpt_back5]...Done
Saved to : C:\UMTool\QcFire\Read\SD8250\
Operation Finished.
QcFire Ver. 6.1
