Operation : Repair IMEI
Searching for Device in FTM Mode...Found
Port : ZTE Handset Diagnostic Interface (COM8)
Hardware ID : usb\vid_19d2&pid_0500&rev_0310&mi_00
Compile : May 18 2017 22:21:07
Release : Mar 06 2017 23:00:00
Hw. Ver. : 8952.gen
Software : P852A11V1.2.0B09_MR
IMEI : 860567030360736 / 860567030360744
Reading QCN Data...Done
Saved As : C:\UMTool\QcFire\QCN_Backup\8952.gen_P852A11V1.2.0B09_MR_860567030360736_190304_133412.qcn
Switching to EDL Mode...Done
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Android HS-USB QDLoader 9008 (COM4)
Driver Info : TCL, qcusbser.sys, 2.1.2.1
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1209700 [8952] 04000000
OPK_DATA : E8905D68B0F309D55B9E28678BFCB56A2447AF1F730EC152AEBEF94F0DB377C8
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8952_006]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8952, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE ZTE B2017G [msm8952]
Software : ZTE B2017GV1.2.0B09, 20170519.163520 [Fri May 19 16:35:15 CST 2017]
Android Ver. : 7.1.1
Patch Level : 2017-06-01
Saving EFS Backup.......OK
EFS Backup : EFS_ZTE_ZTE B2017G_ZTE B2017GV1.2.0B09_2017-06-01_190304_133600.ueb
Reset EFS (Full)......Done
Processing background tasks...Done
Restoring QCN Data...Done
Finalizing process...Done
Operation Finished.
QcFire Ver. 3.8
FTM modda yapdi amma sebeke yine yok